Foosball.com Forums

Chat Area => General Chat => Topic started by: Jackstraw18 on December 19, 2020, 01:36:07 PM

Title: Tornado Twister replacement bearing or bearings
Post by: Jackstraw18 on December 19, 2020, 01:36:07 PM

Would anyone have a link to purchase a few replacement bearings for a Tornado Twister table. Not sure if they are split or snap in whole bearing.

If you have quick directions on replacing... I would take them as well. Bit of a noob here. Thanks everyone.

Title: Re: Tornado Twister replacement bearing or bearings
Post by: bolt115 on December 19, 2020, 04:01:47 PM

https://shop.foosball.com/fts-110-040.html

I think that is the 1 inch side wall...but if it is the 1.5 inch

https://shop.foosball.com/fts-110-043.html

You probably have to remove men and rod to replace so not quick. Hopefully someone else can offer specifics on changing bearing.

Title: Re: Tornado Twister replacement bearing or bearings
Post by: Jackstraw18 on December 19, 2020, 04:58:37 PM

Thank you... Its the 1 inch sidewall...
What are the steps to actually remove the snap in bearing?
Do you have to remove handle using Punch Pin?
How do you collapse the teeth of the bearing?
Thanks again for any help and explanation. The group has been great.