Foosball.com Forums
Chat Area => General Chat => Topic started by: yvesgiot on December 25, 2013, 02:43:32 AM
-
Hello,
just received a new (tournament used) table coin op. Looking inside there is a counter. I suppose that every time you activate the mechanism it should add 1.
Counter is working if I move the arm manually but, when turning, the ball holder doesn't touch the counter arm so it doesn't count.
Anybody had same issue ? Any way to regulate this easily ?
Thanks
Yves
-
the arm the mechanism is supposed to hit is in wrong position i would remove counter with screw driver and loosen and adjust arm so mech will contact it when turning although if you are not using in a commercial setting where you need to reconcile game count with monies i would not worry about it
-
Thanks fro answer, I will try. No I don't need it it is more by curiosity and to make sure everything is in working condition.
Thanks
Yves