Foosball.com Forums
Chat Area => General Chat => Topic started by: Hokiejoe on September 25, 2020, 10:57:21 PM
-
Hello, new here to the forum! I have an older Champion Rene Pierre table, and after years of abuse by some nephews and such, I have a few bent rods making the push and pull action very hard. I assume straightening them out is out of the question. Where can I find replacement rods? It looks like the men are glued on as I do not see any screws, so might have to buy player specific rods if available. Thanks for any help!
-
I googled "Rene Pierre rods". This comes up, an online store that sells Rene Pierre rods.
https://www.gametables4less.com/productcart/pc/Ren-Pierre-Foosball-Table-Replacement-Rods-99p2636.htm
-
Depending on the age of the table, be careful ordering from that link. RP used 15mm rods on older tables and then transitioned to 14mm. No idea when but I would make sure you know which rods you have before ordering, as those parts are seriously expensive.
-
Depending on the age of the table, be careful ordering from that link. RP used 15mm rods on older tables and then transitioned to 14mm. No idea when but I would make sure you know which rods you have before ordering, as those parts are seriously expensive.
Thanks to both of you!