Foosball.com Forums

Champion Rene Pierre rod replacement?

0 Members and 1 Guest are viewing this topic.

Champion Rene Pierre rod replacement?
« on: September 25, 2020, 10:57:21 PM »
Hello, new here to the forum! I have an older Champion Rene Pierre table, and after years of abuse by some nephews and such, I have a few bent rods making the push and pull action very hard. I assume straightening them out is out of the question. Where can I find replacement rods? It looks like the men are glued on as I do not see any screws, so might have to buy player specific rods if available. Thanks for any help!

Re: Champion Rene Pierre rod replacement?
« Reply #1 on: September 30, 2020, 08:42:56 AM »
I googled "Rene Pierre rods". This comes up, an online store that sells Rene Pierre rods.

https://www.gametables4less.com/productcart/pc/Ren-Pierre-Foosball-Table-Replacement-Rods-99p2636.htm


Offline alaskan thunder

  • *
  • 572
  • https://www.facebook.com/groups/firstcoastfoosball
Re: Champion Rene Pierre rod replacement?
« Reply #2 on: September 30, 2020, 02:24:27 PM »
Depending on the age of the table, be careful ordering from that link. RP used 15mm rods on older tables and then transitioned to 14mm. No idea when but I would make sure you know which rods you have before ordering, as those parts are seriously expensive.

Re: Champion Rene Pierre rod replacement?
« Reply #3 on: September 30, 2020, 03:01:30 PM »



Depending on the age of the table, be careful ordering from that link. RP used 15mm rods on older tables and then transitioned to 14mm. No idea when but I would make sure you know which rods you have before ordering, as those parts are seriously expensive.

Thanks to both of you!